Envoy 1-4 Zone Conventional Fire Alarm Control Panels Specifications Page 37
- Page / 58
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Notification
Appliances
Hazardous Location
Devices
Door Holders
& Relays
31
SUBMIT
Initiating
Devices
EST3
Intelligent Initiating Devices
Synchronization Output Module
The Synchronization Output Module is an intelligent device that connects a supervised
output circuit to a 24 Vdc riser. The output wiring is monitored for open circuits and short
circuits. A short circuit will cause the fire alarm control panel to inhibit the activation of
the audible/visual signal circuit so the riser is not connected to the wiring fault. Upon
command from the Signature loop controller, the Auto-Sync Output Module connects
the output circuit to the riser input. The output circuit operates polarized audible and
visual appliances that have an adjustable resynchronizing feature.
SIGA-CC1S Synchronization Output Module (One-gang standard mount) Catalog Sheet: 85001-0543
SIGA-MCC1S Synchronization Output UIO (Plug-in) Module Catalog Sheet: 85001-0543
Input/Output Module
The Input/Output Module is an intelligent device that provides the following
modes of operation:
• Output with monitor input
• Input/programmable output
• Input/direct output
SIGA-IO Input/Output Module (One-gang standard mount) Catalog Sheet: 85001-0533
SIGA-MIO Input/Output UIO (Plug-in) Module Catalog Sheet: 85001-0533
Waterflow/Tamper Module
The SIGA-WTM Waterflow/Tamper Module is a two circuit intelligent module. Circuit 1 is for Class B
normally-open waterflow alarm switches. When the input contact is closed for approximately 16
seconds, an “alarm” signal is sent to the loop controller. Circuit 2 is for Class B normally open dry
contact supervisory and tamper switches. When the input contact is closed, an “active” signal is
sent to the loop controller. Conditions on both circuits are latched at the module.
SIGA-WTM Waterflow/Tamper Module (One-gang standard mount) Catalog Sheet: 85001-0297
Isolator Module
The SIGA-IM Isolator Module is an intelligent device that allows part of the Signature data
loop to continue operating in the event of a short circuit. The module can be wired into a
Class A data loop at any point. A maximum of 96 isolator modules can be installed on one
circuit. If a fault occurs, the isolator cuts power to all devices beyond the isolator on the loop.
Once activated, the line fault isolator continuously checks the faulted side of the loop to
determine if the short still exists. When the fault is cleared, the module automatically restores
the entire data loop to its normal condition.
SIGA-IM Fault Isolator Module (Two-gang standard mount) Catalog Sheet: 85001-0271
Monitor Module
The SIGA-MM1 is a single-circuit intelligent module that includes a Class B normally-open dry
contact. This is used for monitoring input from devices such as fans, dampers, and doors.
When the input contact is closed, an “active” signal is sent to the loop controller. The active
condition is not latched at the module.
SIGA-MM1 Monitor Module (One-gang standard mount) Catalog Sheet: 85001-0297
SIGA-IM
SIGA-IO
SIGA-MMIO
SIGA-CC1S
SIGA-MCC1S
SIGA-WTM
SIGA-MM1
- EST3 Life Safety 1
- Platform 1
- ____________________________ 2
- EST3 Submittal Guide 4
- Quality and reliability 5
- Redefining Life Safety 6
- EST3 Network 7
- Survival of 8
- Central Processor Unit 9
- Network Communication Card 9
- RS-232 Communication Card 9
- Local Rail Modules 10
- Initiating Devices, p.25 11
- Off Premise Signaling Module 12
- Modem Communicator 13
- Control, Display 14
- & Annunciation 14
- FireWorks™ 15
- Envoy Graphic Annunciator 16
- Remote Annunciators 17
- Remote Annunciator Cabinets 17
- To TB1 on 3-ANNCPU1 17
- 12 435678910 17
- Ethernet 18
- Networking 18
- EST3 Panel 19
- Audio Amplifiers (Zoned) 20
- Audio Amplifiers (Banked) 20
- Remote Microphones 20
- Security & Access Control 21
- Card Reader Controller 22
- 5355AGK0009 Shown 23
- Proximity Access Cards 24
- Cabinets & Chassis 25
- Power Supplies 26
- Remote Booster Power Supply 27
- Network Accessories 28
- RS-232 Optical Isolator Card 29
- CDR-3 Coder 29
- MTM March Time Module 29
- Network Short Haul Modem 29
- Ground Fault Detection Module 30
- Alphanumeric Pager Interface 30
- Communications Bridge 30
- Intelligent Analog 31
- Initiating Devices 31
- Detectors and Bases 32
- Standard Detector Base 33
- Isolator Detector Base 33
- Relay Detector Base 33
- Input/Output Modules 34
- Digital Message Module 35
- Universal Class A/B Module 35
- Class B Input Module 35
- Initiating 36
- Devices 36
- Synchronization Output Module 37
- Input/Output Module 37
- Waterflow/Tamper Module 37
- Isolator Module 37
- Monitor Module 37
- Releasing Module 39
- Dual Input Security Module 39
- Manual Pull Stations 40
- Audio Amplifiers 41
- Auxiliary Power Supplies 41
- Accessories 42
- Manual Station Relocator 43
- Stopper II 43
- Notification 44
- Appliances 44
- Wall Strobes 45
- Horns & Chimes 45
- Wall Speakers and 46
- Speaker-strobes 46
- Ceiling Speakers 47
- Horns, and Strobes 47
- Harsh Environment 48
- Firefighters’ Telephones 49
- Audible Signals 49
- Hazardous Location Devices 51
- Notification Appliances 53
- Door Holders 54
- SPDT Relays 55
- Submittal Guide 56
- EST3 SUBMITTAL GUIDE 57
- SUBMITTAL PLANNER 57
- 85010-0099, Issue 8 58
- Security 58
Related products and manuals for Fire protection Envoy 1-4 Zone Conventional Fire Alarm Control Panels
(18 pages)© 2020, manymanuals.com. All rights reserved. | 4.183 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals